I love finding ways to make super fun fashion things for myself. So when I stumbled across this tutorial on how to make your own macrame bracelet, I had a total “Shut up!” moment. I mean, now if you can’t find exactly the perfect bracelet, you can just make your own. So stinkin’ easy!
Huge thank you to Honestly…WTF for posting this ah-mazing do it yourself-er.
- 4 yards of 0.5mm chinese knotting cord
- a connector or charm
- an embroidery needle
- a pair of scissors
- flat nose pliers (optional)
- a lighter (optional)
Start by cutting the knotting cord into two 30 inch, two 20 inch and one 10 inch lengths. Fold the 20 inch piece in half, pull the loop through the ring, fold it over the ring, and pull the rest of the cord through the loop. Repeat the step on the other side of the ring. These strands will be anchored and remain stationary.Center the 30 inch cord under the two middle strands. Fold the right cord over the middle strands and under the left cord. Pull the left cord under the right and middle strands and through the loop on the right side.
Center the 30 inch cord under the two middle strands. Fold the right cord over the middle strands and under the left cord. Pull the left cord under the right and middle strands and through the loop on the right side.
Pull tightly and slide the knot up to the top.
Finish the 2nd half of the square knot by folding the left cord over the middle strands and under the right cord. Pull the right cord under the left and middle strands and through the loop on the left side.
Pull tightly and repeat the steps – left, right, left, right . . . Continue knotting until the desired length is reached. Keep in mind that the clasp will take up approximately half an inch.
To finish the knots, thread one of the cords onto a needle and sew up the center of 3-4 knots along the backside. Pliers will help pull the needle through the tight knots.
Repeat the same step on the other cord.
After sewing up both knotting cords, trim away any excess. Save the scraps and melt the tips with a lighter to seal it for extra hold. Repeat the same exact step on the second half of the bracelet.
To make a sliding closure, shape the bracelet into a circle and overlap the middle strands. Use scraps to temporarily tie the cords together at each end.
Take the 10 inch cord and center it under the strands. Start tying square knots exactly the same way the bracelet was executed.
Stop at about half an inch and sew the knotting cords into the backside of the closure. Remove the temporary ties.
The two sets of middle strands are now the adjustable ties of the bracelet. Adjust to fit the wrist and tie each end into knots. Trim away any excess.
Your adjustable knotted bracelets are finished!
Absolutely beautiful! I can’t wait to try my hand at this and then get to stacking! I will post my attempt as soon as I can give it a whirl. Be sure to head over and check out Honestly…WTF! Stay beautiful!
*Huge thank you to Honestly…WTF for this tutorial. All pictures are their property.